Support · Known issues

Rapid taps on the TV controls may be declined

Fixed in CastEdge 2026.10.14.1406 (15 October 2026). A refused tap is now retried automatically, so an ordinary quick double tap works.

For suite guests, venue operations · Updated 2026-10-15

Reference: KI-0001 · Status: fixed in CastEdge 2026.10.14.1406 · First seen: 29 September 2026 · Fixed: 15 October 2026

What you see

On the phone controller, you tap Channel ▲ / ▼, volume or mute several times in quick succession. Some of the taps have no effect, and the controller shows a message saying the TV didn't accept the command.

Why it happens

The system that drives the displays at your venue limits how many commands it will accept for one TV in quick succession, and refuses the extra ones. Mediacast passes that refusal through rather than pretending the command worked.

What to do

Nothing, once your venue is on the fixed release (below). If a tap is still refused — which can happen when a control is tapped many times in a row very quickly — wait about a second, then tap again. The taps that were accepted are applied correctly: nothing is sent to the wrong TV, and no command arrives late or twice. For a big channel change, use the channel keypad or the guide instead of holding down Channel ▲.

Who is affected

Guest and staff controllers at venues whose displays are driven by VisionEDGE Director. It is most noticeable on channel up/down and on repeated volume taps.

Fix

Fixed in CastEdge appliance release 2026.10.14.1406, 15 October 2026. When the venue's TV control system refuses a command, the appliance now waits a moment and sends it once more, so an ordinary quick double tap goes through. This covers channel, power, mute and volume.

The fix runs on the appliance in your venue, so it applies once that release is installed there; Mediacast installs it for you. This page stays listed for 90 days after the fix.